ONE SHEET BEFORE A WHOLE SET
Check the fit.
Then print the gaps.
A free print size test for your Pokémon binder placeholders. Measure a 63 × 88 mm outline and two 50 mm rulers before you spend paper and ink on a collection.
One page each · No account needed · Original measurement guides, no card artwork
FOUR QUICK CHECKS
A ruler, a test page,
and you’re ready.
- Match the paper. Download A4 for A4 paper, or US Letter for Letter paper. Match both the print dialog and the paper in your tray.
- Keep the scale at 100%. Choose Actual size. Turn off Fit, Shrink and automatic borderless enlargement. A PDF viewer may word these settings differently.
- Measure both directions. Both rulers should measure 50 mm. The outline should measure 63 mm wide and 88 mm tall, along the centers of its border lines.
- Check a trimmed sample. Cut the outline and try it in an empty sleeve or pocket. The sheet checks print size; it doesn’t promise a fit in every sleeve or binder.
What did your test show?
| Your printed sheet | What to check next |
|---|---|
| Both rulers are 50 mm; the outline is 63 × 88 mm | The print is at the intended size. Check a trimmed sample in your sleeve, then use the same paper and settings for your placeholders. |
| Both rulers are too short or too long | Check for Fit, custom scaling, a paper-size mismatch or borderless enlargement. Choose Actual size / 100% and print the test again. |
| The horizontal and vertical measurements differ | Recheck how you measured. If it persists, try another PDF viewer or the printer’s recommended driver before printing a batch. |
| The page is cropped | Check the loaded paper, the selected page size and your printer’s printable area. Shrinking to hide cropping also changes the placeholder size. |
Adobe documents Actual size as printing without scaling. Your printer and viewer still control the physical result.
SIZE CHECKED. COLLECTION NEXT.
Leave a place for the next find.
Choose a set, mark what you own, and print placeholders for the missing cards. Binder pocket count changes the preview; it doesn’t change the 63 × 88 mm insert size.